DGN2200 and static route

[marine1]

Need some help please guys,
I am trying to set up a CCTV DVR.
I have set up DYNDNS and when I click on the address: xxxxx.kguard.org it opens up my router (user and pass)

How do I set it up that it goes to the DVR which is 192.168.0.9
I tried it under static routes but it firstly does not save the .9
I tried also using 192.168.0.100 same thing when I save it, it saves it as 192.168.0.0

Not sure why
Need some help please

[Dean]

You don't want Static Routes, you want Virtual Servers (or port forwarding).

Set a specific port (whatever you want - put into both start and end port textboxes) on your router to forward the traffic to 192.168.0.9 (or whatever you choose as your DVR's static IP).

[marine1]

Seems it is in the firewall section but still when I enter : xxxx.kguard.org it goes straight to my router password and username.

I have set the Kguard CCTV DVR to port 200 and enable all incoming traffic on all ports to go to the KGUARD IP address internal 192.168.1.5
Still nothing
Even if I use xxxxx.kguard.org:200 - nothing happens, says invalid or unable to reach

[marine1]

Anyone able to help on Teamviewer?

[Dean]

Anyone able to help on Teamviewer?

Sure, PM your ID and pass

EDIT: bandwidth is dodgy today so hopefully the session won't be too slow - otherwise may have to wait til tomorrow/Mon.

[T-Man]

Have someone from outside your network try it. It doesn't work from inside using the DynDNS.

[marine1]

I seem to have fixed it.
The latest firmware for the router is beyond a joke.
I went back to 1.0.0.20 and there it has the settings needed.
Worked like a charm.
You have to set up port forwarding for port 80 and again for port 9000.
Both have to be enabled for Kguard to work.