If your wlanAP supports WDS then setup a both with WDS and put it half way between your AP and the required coverage area.
Make sure that you use the same SSID, security and channel for WDS to work.
This is quite important, and something that I made a mistake with when I first setup a network with repeaters. Quite a few wireless routers (Most Netgears, most of the telkom ones, etc.) don't have Wireless Distribution System (WDS) built in. This means that you cannot go out and buy a wireless access point, and hook it up to your current router (unless the router has WDS).
To solve this problem, I used the following:
- 1 x Netgear DG834 (but any router will do - doesn't need to be wireless)
- 1 x Wireless Access Point (connected to the router through wired LAN)
- X x Wireless Access Points needed to extend your network (connected through wireless to the above AP).
I use the following Access Point: http://www.netgear.com/Products/APsWirelessControllers/AccessPoints/WG602.aspx
Alternatively, buy a router with WDS. And then connect the AP's to this.
Hope this helps,
Nick
Fair enough. I found my supplied solution very easy to setup, and the only hardware I needed to purchase was two additional access points. But then I'm not a CTWUGger and so obviously have less experiance![]()
You are not perhaps interested in becoming a CTWUGGER? Well be having a meeting on 9 Feb 2008, so if you are interested in joining send me a pm and i'll give you details as to where the meeting will be held.
The tips on WDS are useful, thanks allQuite a few wireless routers (Most Netgears, most of the telkom ones, etc.) don't have Wireless Distribution System (WDS) built in.
But isn't it possible to get APs significantly cheaper than routers (powerful or not)? I feel like I'm being cheated ...I would much rather point him in the direction of 2 linksys WRT routers if he wants to do wds, flash them with custom firmware and you have 2 powerful wireless routers.
The WRT54GL is not an ADSL router, but it goes for R500-R600. An AP that has routing capabilities, doesnt mean that its an ADSL router.