Recent content by antonhill

  1. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    HI Leon, turns out that the BMS is shot on that one Lipo 12V. The supplier does not have stock of 12V, but is willing to supply 1x24V 100a replacement. The question is can the Mecer inverter run on one battery? Or does it need a pair of 12V batteries?
  2. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    I would agree and thank you very much for your input. Have a good evening
  3. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    Yes, one batt had no voltage and the inverter died, ie same issue as before even after the recharge
  4. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    Thanks, would you agree that a BMS reset could be a solution?
  5. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    Hi Leon, just some feedback on this one. After we spoke I charged each battery individually, the charger indicated that they were charged to 14.7V each. I then connected them in parallel and charged them again. I them installed them back in the inverter with the balancer and did the one light...
  6. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    Thanks Leon will do
  7. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    I will have to check the warrantee situation on the battery. I bought them from GPBatteries and they were delivered on 14 January 2023. Will let you know. Thanks for taking the time to assist me.
  8. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    I understand, thanks Leon. I will see what happens and report back. Have a good one
  9. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    Yes that is exactly what happens, one battery 12V and other close to nothing. Do you recommend I discharge them a bit first before recharging? I will recharge individually with a Victron Blue Smart Charger until full and then connect back up and see. If it still does this I assume it's a cell...
  10. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    Thanks for the feedback. Voltage on each when fully charged is 14.2V.
  11. A

    Mecer 2400VA Inverter (Community Support) - Part 2

    I have a 24V Mecer setup and recently drop in 2 x 12V Lithium Ion batteries with a load balancer. It was working great, BUT suddenly the unit just switches off when load-shedding hits. I measured the voltage before and it measure correctly at 24.7V accross both. I also put the batteries on a...
See more
Back
Top
Sign up to the MyBroadband newsletter
X