Recent content by Jay-Dee

  1. J

    Paradox Alarm - Stay / Sleep LEDs

    So after manually programming via the keypad, I have gone into Babyware and for anyone looking in the future... It is under "Non-reportable event" and then Arm in stay/sleep mode Thank you so much... Got it working perfectly. I can now ask "Hay Google is the Alarm Sleep / Stay on" and get an answer
  2. J

    Paradox Alarm - Stay / Sleep LEDs

    Still cant find it, sadly. Babyware and Winload both only allow me to define per Partition and not type of arming (unless you know where I should be looking) Will try keypad programming a little later..
  3. J

    Paradox Alarm - Stay / Sleep LEDs

    Been a while since I programmed / setup in either.. I was struggling to find a copy of BabyWare but just found one and am busy installing. Could not find how to do it in Winload, only the Full Arm status. If I cant get it done in Babyware, will do it via the keypad Thanks again
  4. J

    Paradox Alarm - Stay / Sleep LEDs

    I am not using Home Assistant, hence not wanting to install it for or an Arduino for 1 function
  5. J

    Paradox Alarm - Stay / Sleep LEDs

    Thank you very much... Going to re-read that section now and will program as above from the keypad. Out of interest, any idea if it is possible via Winload?
  6. J

    Paradox Alarm - Stay / Sleep LEDs

    As mentioned in the original post, I already have an LED programmed with the PGM but this lights up for all types of arming. I am wanting to only light up on Stay or Sleep. I don't want to integrate 3rd party items into the alarm as it is just another point of failure. I am just wanting to...
  7. J

    Paradox Alarm - Stay / Sleep LEDs

    Can anyone help.. I have an LED connected to the PGM on my Paradox SP6000. The LED illuminates no matter how I arm the alarm but I am trying to work out how to have separate LEDs for Stay, Sleep and Full Arm. Can this be done? via PGMs? Thanks in advanced
See more
Back
Top
Sign up to the MyBroadband newsletter
X