Recent content by Kz_

  1. K

    auto restart after "battery voltage is too low" warning

    during charging yes :X3: but not during discharge
  2. K

    auto restart after "battery voltage is too low" warning

    150ah + 200ah
  3. K

    auto restart after "battery voltage is too low" warning

  4. K

    auto restart after "battery voltage is too low" warning

    I have tested and I can go through the night oftentimes, if I did get good charge during the day depending on the weather. The load is just around 150W If I don't and the grid is available. the grid will kick in, mostly an hour to daylight. The issue will arise when batteries are low and the...
  5. K

    auto restart after "battery voltage is too low" warning

    panel power ranges from 300W to 800W depending on the weather and time of day. it is always on SBU
  6. K

    auto restart after "battery voltage is too low" warning

    Got it. I see, it could be some inherent challenges with my exact setup. Curious though, which other inverter options overcome this challenge?
  7. K

    auto restart after "battery voltage is too low" warning

    I'll recheck this with precision to be sure
  8. K

    auto restart after "battery voltage is too low" warning

    2 lifepo4 batteries in parallel
  9. K

    auto restart after "battery voltage is too low" warning

    at the exact time when I observe this. load is very small. about 150W. it would be drawing not more than 15A
  10. K

    auto restart after "battery voltage is too low" warning

    The measured voltage is usually quite close to what is displayed on the inverter. I can retest with exact precision how much drop it gets under load, but it is in that range, quite significant. but for this case, I guess that the voltage drop is what moves the voltage to a region under the set...
  11. K

    auto restart after "battery voltage is too low" warning

    I think I might have figured out what exactly causes the issue, but not the solution. I don't know if other users face this, but the voltage indicator varies greatly depending on whether the battery is charging or discharging. for example, it can show 12.9V while charging, but if charging stops...
  12. K

    auto restart after "battery voltage is too low" warning

    #20 and #21 only work when the grid is available and is connected to the charger as a source. i.e. during the day when the PV is on, these settings don't apply. Also if the grid is down, these settings don't apply. #21, yes it does stop charging. when the grid is the only source available, for...
  13. K

    auto restart after "battery voltage is too low" warning

    the grid connection exists. only that the few times this happens is when the grid is down. the situation doesn't happen when the grid is available.
  14. K

    auto restart after "battery voltage is too low" warning

    the setting is at 12.0V which is the highest allowable on the device. The battery isn't dead. it's just that the inverter seems to want to cut it off from the inverter. infact all the while that it is flashing the low voltage error, it is usually charging as well.
  15. K

    auto restart after "battery voltage is too low" warning

    01. Output source priority selection -- SBU 05. solar supply priority – LBU 06. overload bypass – bye, bypass enabled 07. autorestart when overload occurs – enabled 08. autorestart when overtemperature occurs – enabled 10. charger source priority – CSO 11. maximum charging current – 60A 13...
See more
Back
Top
Sign up to the MyBroadband newsletter
X