Alarm Configuration Query/Assistance

[Dames]

Anyone perhaps familiar with this panel...? I have a configuration question which I think should be pretty simple to solve - tried going through the manual I could find online but wasn’t able to find what I need. Basically has to do with setting what zones actually trigger the alarm when armed.

If you might be able to assist can you send me a PM? Thanks!

 

[Tinuva]

Looks like dsc alarm.

Temporary zone bypass is *1 then zone nr followed by a #. Need to do it for each zone, before every arm.

Permanent solution is, you need the master programing pin. Not same ad the regular pin.

Only installer will know this code.

 

[Tinuva]

Other option is to completely reset the alarm. Need a complete reprogram from scratch.

 

[neoprema]

Its a DSC, if it was installed at the same time as mine (they look identical), its a Power Series 1616 or 1832/64

When the system is alarmed, disarm it. The system will go into "alarm log" mode automatically and flash the zone(s) which triggered the alarm. This only occurs for a while ,so take note. So if you disarm while its going off an 4 flashes, it means Zone 4 set off the alarm.

Alternatively, to see which zone triggered the alarm, when the alarm goes off (or after disarm) ,press *3
The lights will flash indicating which zone(s) triggered the alarm last.

I've got the full manual if you need it. Without an LCD it is not easy to use. I fitted a PK5500 but the DSC is just a pain anyway.