Can anyone see something wrong in my Cisco config?

[TheGuy]

Hi Guys

Problem is user on the inside cannot break out onto the internet. This is a diginet line.

Any ideas?

ip subnet-zero
!
!
!
!
interface Ethernet0
ip address 192.168.0.1 255.255.255.0
ip nat inside
!
interface Serial0
ip address 196.30.238.91 255.255.255.252
ip nat outside
!
ip nat inside source list 1 interface Serial0 overload
ip nat inside source static tcp 192.168.0.1 3389 196.30.238.91 3389 extendable
ip classless
ip route 0.0.0.0 0.0.0.0 Serial0
no ip http server

 

[TheGuy]

Just to add I can ping from the router but if I specify the source as the Ethernet address then there is a problem

 

[TheGuy]

Solved it had to add a permit rule to the source-list to allow the traffic

 

[dabouncer]

Your original post did not include the access-list so no wonder it did not work.
access-list 1 permit 192.168.0.0 0.0.0.255

Why are you using standard access-lists anyway? Extended is better for NAT.

 

[TheGuy]

Your original post did not include the access-list so no wonder it did not work.
access-list 1 permit 192.168.0.0 0.0.0.255

Why are you using standard access-lists anyway? Extended is better for NAT.

Thanks still new at configuring these routers but will read up on the standard versus extended.

 

[srothman]

Why are you using standard access-lists anyway? Extended is better for NAT.

Not always ;-)

 

[dabouncer]

Please do no nat between 2 subnets using standard access lists thereafter please do pat inbound with a standard access list.