Here is my scenario
I have my Router in half bridge mode, connecting an account for me(local only) and then i dial my international account when needed/with route sentry. But my router fails to keep the local account connected, it disconnect after a long time and never connects again. Here is the pppoe connection setup, can some one check if something is set wrong:
PORT: 0
VPI: 8
VCI: 35
VLAN Mux: unchecked
Service Category: UBR without PCR
QOS: Unchecked
Encapsulation Mode: LLC/SNAP-Bridging
Authentications Method: Auto
Dial on Demand: Unchecked
PPP IP Extension: Unchecked
Use Static ip: Unchecked
Retry PPP password on authentication error: Checked
PPP Debug Mode: Unchecked
KeepAlive: Checked
Bridge PPPoE frames between WAN And Local Ports: Checked
NAT: Checked
Firewall: Checked
IGMP Multicast: Checked
WAN Service: Checked
I have my Router in half bridge mode, connecting an account for me(local only) and then i dial my international account when needed/with route sentry. But my router fails to keep the local account connected, it disconnect after a long time and never connects again. Here is the pppoe connection setup, can some one check if something is set wrong:
PORT: 0
VPI: 8
VCI: 35
VLAN Mux: unchecked
Service Category: UBR without PCR
QOS: Unchecked
Encapsulation Mode: LLC/SNAP-Bridging
Authentications Method: Auto
Dial on Demand: Unchecked
PPP IP Extension: Unchecked
Use Static ip: Unchecked
Retry PPP password on authentication error: Checked
PPP Debug Mode: Unchecked
KeepAlive: Checked
Bridge PPPoE frames between WAN And Local Ports: Checked
NAT: Checked
Firewall: Checked
IGMP Multicast: Checked
WAN Service: Checked