Hi there all. I have a 2014 ford kuga 1.6 ecoboost. I have done the software remapping on it in February 2019 and car was pulling like a bomb. I recently had an exhaust leak on the outlet side before the turbo which i had to remove the turbo to repair this. During the time i did the downpipe on it as well and had the CAT removed. After all was put back together the car is not pulling like it was and sometimes engine light comes on showing O2 sensor issues. Car is also jerking from time to time. Is there any advise of what i can look at?
-
Join the MyBroadband community
South Africa’s biggest forum. Discuss, discover, and connect with thousands of members.
-
Question of the Day: What's the most interesting small town you've visited in South Africa?
Ford kuga issues
- Thread starter Jeanpier
- Start date
Yes unobeat. I had a minicat installed as recommended by exhaust specialist. I am not sure if i might have adjusted something on the wastegate when all was removed. And not sure how to check this but car is not pulling close ro how it was.
Thanks. I will look into that however i dont think its the software they done as it only started after i removed the turbo to fix the exhaust leak and then did the downpipe. They will again try to rip me off by saying they need to redo the tuning due to the changes done.
But thanks for advise
Undertaker015
Active Member
- Joined
- Nov 21, 2017
- Messages
- 41
- Reaction score
- 15
Get the car scanned to find the fault ?
ReeceDBN031
Expert Member
i think there was an issue prior to when you had software done. so when you went and had everything sorted out perhaps not that its all fixed with no leaks the software is out of sync with the systems
Hi. I had the car scanned and there is no faults coming on the diagnostic.
Could be specific parameters in the map. Some Maps will be specific for whether you have a cat installed or not.