Gate repair?

[STS]

So this is how I looked after my son released the handbrake on the car and drove over me and the gate



The gate however didn't make it. It's a standard gate that is on hinges, and you slide it back and forth to open it. it wasn't perfect to begin with, but since the car knocked it out the metal it runs along is even more damaged. Who would be a good person to contact to repair a non-electronic gate?

Randburg/Northcliff

 

[biena]

Which area, I know a few people in betweennowhereandnothing but doubt that would help.

 

[STS]

Which area, I know a few people in betweennowhereandnothing but doubt that would help.

Doh, soz

 

[Pho3nix]

Randburg/Northcliff

STS lives near me :erm:

As to your question, ask any metal welder in the area to assist. The gate at my parents gate did the same and that "fixed" it.

 

[STS]

STS lives near me :erm:

As to your question, ask any metal welder in the area to assist. The gate at my parents gate did the same and that "fixed" it.

how much did it cost about? i imagine i could fix it with a hammer and muscles but unfortunately lack the muscles to carry a 4 meter 100 kg gate

 

[Pho3nix]

how much did it cost about? i imagine i could fix it with a hammer and muscles but unfortunately lack the muscles to carry a 4 meter 100 kg gate

I'll prod my dad and ask him but doubt it was more than One or Two hundred bucks odd.

 

[shakes1]

Think I know someone that can help, please PM me for his number.

 

[DerpiesFreud]

Yoh,my dad did the same thing a few years back,luckily the car wasn't even scratched,the door we had to hammer/panelbeat straight... then re calibrate the motor

the gate is still slightly bent...