Mikrotik assistance

[Shnorkiller]

Hi all,

We are trying to setup an RB 2011 to run a hotspot from.

The hotspot is working perfectly and, once connected to the hotspot I can gain access to Winbox without any hassle (this is on the 10.0.0.0 range and is off eth2). The problem comes in when I connect on the ADSL side of the mikrotik (on the 192.168.1.0 range, the mikrotik is connected to an Adsl router through eth1), I am connecting to a Tenda router via wifi and I can ping the mikrotik's IP address from my PC. When I open Winbox however, I can't connect to the RB and it doesn't pick the RB up. There is another RB on the same network range connected to the Tenda and I have no problem accessing and configuring that RB through Winbox.

Any help would be hugely appreciated!

 

[controlc]

Some of the Mikrotik routers have default rules on them to prevent access from ether1.

Ensure that there's no non-hotspot firewall rules under IP->Firewall->Filter. Also ensure that ether1 is enabled under IP->Neighbors->Discovery Interfaces

 

[Shnorkiller]

Some of the Mikrotik routers have default rules on them to prevent access from ether1.

Ensure that there's no non-hotspot firewall rules under IP->Firewall->Filter. Also ensure that ether1 is enabled under IP->Neighbors->Discovery Interfaces

Thanks so much, will give it a go and report back