ODTech
Senior Member
Hi.
I have a 3 point PTmP link that i'm trying to setup. All 3 radios are connected but i get no RX on the AP.
AP is a Mantbox 19s
Stations are both LHG units
I followed the basic transparent bridge as follows. Did i miss something or anyone got a suggestion?
1. Upgrade firmware to latest stable.
2. Reset radio and remove default config.
3. Create bridge and add relevant ports to it. wlan, eth1, etc..
4. Give bridge an IP or DHCP client setup.
5. Config wlan.
5.1 Regulatory domain South Africa
5.2 Set SSID
5.2 Set wireless to NV2
5.3 Set Frequency to 5520
5.3 No security for the time being.
Then i duplicated the settings on the stations. The stations shows rx and tx traffic but the ap is not receiving.
Edit: Station wireless mode is obviously station-bridge.
I have a 3 point PTmP link that i'm trying to setup. All 3 radios are connected but i get no RX on the AP.
AP is a Mantbox 19s
Stations are both LHG units
I followed the basic transparent bridge as follows. Did i miss something or anyone got a suggestion?
1. Upgrade firmware to latest stable.
2. Reset radio and remove default config.
3. Create bridge and add relevant ports to it. wlan, eth1, etc..
4. Give bridge an IP or DHCP client setup.
5. Config wlan.
5.1 Regulatory domain South Africa
5.2 Set SSID
5.2 Set wireless to NV2
5.3 Set Frequency to 5520
5.3 No security for the time being.
Then i duplicated the settings on the stations. The stations shows rx and tx traffic but the ap is not receiving.
Edit: Station wireless mode is obviously station-bridge.