Mal1ce
Well-Known Member
Hi folks
Trying to restore a MyPBX Standard to operation again after a power failure, have had to reset the device to defaults.
Have managed to setup all the extensions again & inbound/outbound routes but I'm not having much luck with the PSTN trunks... keep getting "the requested number is not available message" when trying to call in.
Does anyone have working settings for?
Busy Detection
Busy Count
Busy Interval
Busy Pattern
Frequency Detection
Busy Frequency
Polarity Detection
Caller ID Start
Caller ID Signalling
Caller ID Detection
Many thanks!
Trying to restore a MyPBX Standard to operation again after a power failure, have had to reset the device to defaults.
Have managed to setup all the extensions again & inbound/outbound routes but I'm not having much luck with the PSTN trunks... keep getting "the requested number is not available message" when trying to call in.
Does anyone have working settings for?
Busy Detection
Busy Count
Busy Interval
Busy Pattern
Frequency Detection
Busy Frequency
Polarity Detection
Caller ID Start
Caller ID Signalling
Caller ID Detection
Many thanks!