Need some assistance with Cisco 805 setup for Diginet

[CyberFish]

Nevermind, sorted it out.

 

[Vallejo]

Hi,

It is easy, before you begin, verify that each computer that will be connected to the router has a network interface card (NIC) installed and that Transmission Control Protocol/Internet Protocol (TCP/IP) has been loaded and configured.

Step 1: Connect the yellow Ethernet cable from the yellow Ethernet port on the back panel of the router to the Ethernet port on the NIC on the computer.

Step 2: Verify that the HUB/NO HUB switch on the left side of the back panel has been set to the NO HUB position (out). If the button is in, press it to set it to the out position.