SMC 7904BRA Router settings - OpenWeb

[LancelotSA]

Hi guys,

I just buggered up....

I was having problems with Skype dropping calls every 3 minutes or so, so I read some solutions and one involved doing a firmware upgrade on one's router. I followed this suggestion but went and forgot to save all my settings on my router before doing so.

My problem now is that I am now unable to connect through my router as I cannot remember what all the settings were on my router when i go into 192.168.2.1... well I assume it is the settings preventing me from connecting?

Please, please could someone on here give me assistance so that I do not have to wait until Monday to phone OpenWeb for help?

 

[LancelotSA]

Just to elaborate, these are the details I reckon I am needing to confirm /change :

ATM1

Protocol
Disable
1483 Bridging
PPPoA
1483 Routing
PPPoE
IP over RFC1483 bridged

VPI/VCI

Encapsulation
VC
MUX
LLC

QoS Class
CBR
VBR
UBR

PCR/SCR/MBS

IP assigned by ISP
Yes
No

IP Address

Subnet Mask

Connect Type
Always Connected
Auto - Triggered by traffic
Manual - Start in Disconnected
Manual - Start in Connected
Manual - Start in Last State

Idle Time (Minute)

Username

Password

Confirm Password

MTU

 

[LancelotSA]

Well guys I discovered through my own trial and error that the VPI/VCI settings were wrong.

Does concern me how few answers relating to ADSL we get on here now.... Off Topic seems to get a lot more attention.

 

[Mephisto_Helix]

Just not that many peeps with that router. Was having probs a while ago and no one else had my router if I can recall properly (same one you have). Just have to be patient bru.

 

[hj2k_x]

I have that router.

Holding a sharp pencil in the reboot button on the back will have your defaults back in no time.