Hey guys
I have a Telkom Mega 100WR connected via USB to my computer.
I am running Windows 7 Ultimate 64bit.
Everything was working fine until I installed another 4GB of ram. My motherboard does support that amount of memory and the kind of memory.
Once the extra 4GB is in and I start up windows my Router is no longer deteced and in the device manager I get this message under the "Device Status" for the router (TI USB Remote NDIS Network Device):
Device status
This device cannot start. (Code 10)
As soon as I remove the ram it works again and other devices work in the same usb port, such as keyboard and flash disk.
The ram I am pretty sure isn't faulty as it came out of a friends PC that was working fine and so far I have had no errors.
System specs:
MSI K9N Ultra
AMD Athlon x2 4200+
MSI 8800GT
Apacer 2x1GB DDR2 800
Apacer 2x2GB DDR2 800
Windows 7 Ultimate
Thanks for any help in advance
I have a Telkom Mega 100WR connected via USB to my computer.
I am running Windows 7 Ultimate 64bit.
Everything was working fine until I installed another 4GB of ram. My motherboard does support that amount of memory and the kind of memory.
Once the extra 4GB is in and I start up windows my Router is no longer deteced and in the device manager I get this message under the "Device Status" for the router (TI USB Remote NDIS Network Device):
Device status
This device cannot start. (Code 10)
As soon as I remove the ram it works again and other devices work in the same usb port, such as keyboard and flash disk.
The ram I am pretty sure isn't faulty as it came out of a friends PC that was working fine and so far I have had no errors.
System specs:
MSI K9N Ultra
AMD Athlon x2 4200+
MSI 8800GT
Apacer 2x1GB DDR2 800
Apacer 2x2GB DDR2 800
Windows 7 Ultimate
Thanks for any help in advance