gate controller

  1. PegZ

    ET 500 Gate Motor not using AC

    Hi All, My ET500 stopped using AC. I tested the transformer 220 V -> 18 VAC. I tested 18 VAC at transformer but only about 4 to 5 VAC at motor control board, when disconnecting the plug, then there's about 17.8 VAC on the wire, so I guess that possibly means something wrong at the PCB pulling...
  2. P

    D5 Evo motor problems

    My D5 Evo Electric gate was fine , one morning when I tried to open it i got a message motor fault. Disconnected. I checked all wires and installed a new battery. Give motor direct power and it work fine. When I tried to restart the gate motor I got Set limits... Doing the reset limit steps it...
Top
Sign up to the MyBroadband newsletter
X