7300 RA and half-bridge mode

[seymour7]

Ok, so I have 3 computers on my network. I want my 5GB int. account to work on all three computers via the connection that the router dials. However, I want my computer to have the ability to dial up the router with a local account and then use something like Route Sentry to direct local traffic through that account. I believe this can be done by setting the router to half-bridge mode. I've been looking for a way to set this Billion 7300 RA to half-bridge mode but can't find anything. The GUI has changed quite a bit from the 7300. Some screenies (it might help):

http://albums.kimag.es/albums/seymour/13204665.png
http://albums.kimag.es/albums/seymour/74000725.png
http://albums.kimag.es/albums/seymour/41124415.png
http://albums.kimag.es/albums/seymour/97800370.png
http://albums.kimag.es/albums/seymour/50310603.png

All help is greatly appreciated.

 

[Snormossel]

http://albums.kimag.es/albums/seymour/41124415.png

If you click on the protocol drop down list from the pic above you should get something like "PPPoE with Passthrough" as an option.

If not PM Billion Tech for a FW upgrade. Think the first FW it was released with did not have this option.

 

[seymour7]

http://albums.kimag.es/albums/seymour/74487341.png
Doesn't look like there's any option for that over there. There are no new FW drivers for download btw. Thanks for the reply.

 

[Snormossel]

http://albums.kimag.es/albums/seymour/74487341.png
Doesn't look like there's any option for that over there. There are no new FW drivers for download btw. Thanks for the reply.

Ok then it could be an older F/W version.

Mail Billion support: support(at)billionsa.com
Or PM Billion Tech.....

 

[seymour7]

Sure, thanks. I'll PM BILLION Tech.

 

[BILLION Tech]

PM received and replied....

 

[seymour7]

Thank you.

 

[BILLION Tech]

Thank you.

No Problem.