Bitswap and SRA

[Johnatan56]

Hi,
My line finally got upgraded to 20mbps, it syncs to the highest it can, which fluctuates between 10-15mbps.
My router tries to sync higher, e.g. if it is currently at 11 it drops the connection and goes to 13-14mbps instead.
Would enabling SRA stop it from dropping the connection or must I request that the line is limited to 10?
Also, should I leave Bitswap on?

Thanks,
The router is a D-Link 2640U, upgrading it soon.

 

[PsyCLown]

Enabling SRA should assist with the line drops.

Bit Swap is only for G.dmt.

 

[Johnatan56]

Enabling SRA should assist with the line drops.

Bit Swap is only for G.dmt.

Thanks, that was my impression, going to disable it (the Bit Swap). Enabled SRA, going to see how it goes.

EDIT: It changed line sync without dropping (increase to 12mbps), so thanks in advance, think the issues are sorted.

 

[fragtion]

Most exchanges aren't SRA enabled right now unfortunately. Hopefuly they change this, giving the user the choice to have it enabled or not, because I'm sure it's just a configuration change at the DSLAM (for supported DSLAMS at least)

 

[PsyCLown]

Most exchanges aren't SRA enabled right now unfortunately. Hopefuly they change this, giving the user the choice to have it enabled or not, because I'm sure it's just a configuration change at the DSLAM (for supported DSLAMS at least)

Yeah, would if not all of them have it enabled yet have support for it - then it should be enabled.

 

[Johnatan56]

Seems to be supported by mine? Have had no drops since I enabled it.