Ellies Cube vs Gizzu Portable

I bought the Gizzu and got it delivered yesterday morning. I'm using now for the first time proper to power 2 x 24" Dell monitors since power went of at 12, so so far it has been running for 1 hour and 19 minutes and it has 90% battery left and says it can keep going for 39 more hours.
3.9
 
Nice. Did you get the 155Wh or a bigger one?

Same one you linked to. It's a nice little unit and I'll be taking it on our road trip/safari in a couple of weeks as well. Comes with a 12V car charger thing too so I'm pretty happy with it.
 
View attachment 1338724

It is longer Acid = 250

Problem is most power stations use 18650 that is not the best idea when it comes to daily 2-3 times charge.

The Gizzu 296Wh says:

The device is recommended to be used as a Power Station; not as an always-on, pass-through solution. It is not recommended to use the device while charging or to leave it constantly plugged into the mains, as this can cause battery degradation.


I am wondering if the same would apply to the 155Wh..... If that is the case then I probably won't even use it daily.
 
The Gizzu 296Wh says:

The device is recommended to be used as a Power Station; not as an always-on, pass-through solution. It is not recommended to use the device while charging or to leave it constantly plugged into the mains, as this can cause battery degradation.


I am wondering if the same would apply to the 155Wh..... If that is the case then I probably won't even use it daily.

I have an extension tray of plugs for my workstation. I removed the two monitor plugs from it and put them on a new lead with a double adaptor head. So when Eskom is up I plug that lead into the extension tray, when it is down I unplug from the extension tray and plug into the Gizzu.

And FYI, after 2 hours 20 minutes of loadshedding the battery percentage read 71% still left after drawing a fairly constant 32W to keep the two monitors running. Once it charges back to 100% I guess I'll unplug from the mains until next time.
 
I have an extension tray of plugs for my workstation. I removed the two monitor plugs from it and put them on a new lead with a double adaptor head. So when Eskom is up I plug that lead into the extension tray, when it is down I unplug from the extension tray and plug into the Gizzu.

And FYI, after 2 hours 20 minutes of loadshedding the battery percentage read 71% still left after drawing a fairly constant 32W to keep the two monitors running. Once it charges back to 100% I guess I'll unplug from the mains until next time.

Why not unplug it when the power comes back on and then use it again until it runs close to 0% rather than recharging immediately?
 
Why not unplug it when the power comes back on and then use it again until it runs close to 0% rather than recharging immediately?

I think I'd rather just keep it topped up with these 4 and a half hour slots becoming more frequent just now. Losing my monitors when the power goes off is seriously annoying :)
 
I went with the Gizzu and it arrived this morning. I plugged just the router and ONT in.

20220705_154241.jpg
 
I went with the Gizzu and it arrived this morning. I plugged just the router and ONT in.

View attachment 1340918

Nice. I've easily been getting through the loadshedding periods with my two monitors attached. This morning was about 2 hours and still had 74% left with a constant draw of 32-33 watts.
 
Top
Sign up to the MyBroadband newsletter
X