Home Automation - Smartkit

[alqassam]

Are you 1000% sure your sv is isolated?

I broke off the 2 resistors.

 

[Steamy Tom]

i will draw you a diagram on the sv side, looks wrong

 

[alqassam]

@3:26 for a "diagram"

Used this video to setup the hardware

 

[Tinuva]

Send a photo of the sv so we can see the wiring. When all wires connected

 

[alqassam]

SV pic

 

[Steamy Tom]

red and black are power from the digidoor + and - (notice how it goes to the bottom power pins)

the red loop is are those inputs closed to a circuit in isolated mode.

green/yellow is to the digidoor com and button/pedestrian

 

[Tinuva]

Both methods will work IMHO.

But, loose wires? You need to solder the wires on. Loose only good while flashing. But the install you solder the wires on or you solder pins on if you have.

 

[alqassam]

Both methods will work IMHO.

But, loose wires? You need to solder the wires on. Loose only good while flashing. But the install you solder the wires on or you solder pins on if you have.

Theyr soldered underneath.

The were two methods. I could try the other, and reconfigure the sonoff. Worth a try

 

[Tinuva]

Theyr soldered underneath.

The were two methods. I could try the other, and reconfigure the sonoff. Worth a try

Why are there long ends sticking out then? It could make contact with other things that could potentially cause your issue.

 

[Steamy Tom]

also, assuming you have inching on?

 

[Tinuva]

I also think you need to take a voltage reading on the sv to make 1000% sure it is really isolated.

 

[Tinuva]

And yes is inching configured.

 

[alqassam]

And yes is inching configured.

What's the command to set inching?

 

[Steamy Tom]

What's the command to set inching?

Tasmota?

 

[alqassam]

Tasmota?

Yip

 

[Steamy Tom]

Yip

Switchretain 1
Powerretain 1
PulseTime1 1
switchmode1 0
switchmode2 2
switchtopic2 "device_name_state"

 

[alqassam]

Switchretain 1
Powerretain 1
PulseTime1 1
switchmode1 0
switchmode2 2
switchtopic2 "device_name_state"

And as easy as that it works


Thank you guys for the help

 

[Steamy Tom]

And as easy as that it works


Thank you guys for the help

anytime bro

 

[Tinuva]

Why do you guys use retain on a SV used on a garage door / gate? I don't get it.

 

[Tinuva]

Have fun with ghost switching. I literally only use pulsetime and that is all that should be on a door switch.