IPv6 Roll Out

I turned on the IPV6 and set it to PPPOE then it works. It does not work on Dynamic on the Archer C6. However, I keep getting WAN errors with the internet disconnecting. Any advice?
 
I turned on the IPV6 and set it to PPPOE then it works. It does not work on Dynamic on the Archer C6. However, I keep getting WAN errors with the internet disconnecting. Any advice?
 
I turned on the IPV6 and set it to PPPOE then it works. It does not work on Dynamic on the Archer C6. However, I keep getting WAN errors with the internet disconnecting. Any advice?
 
jdido87 said:
I turned on the IPV6 and set it to PPPOE then it works. It does not work on Dynamic on the Archer C6. However, I keep getting WAN errors with the internet disconnecting. Any advice?
Click to expand...

Do you have a screenshot of the settings?
 
AfriNatic said:
If you have a D-Link please change you IPv4 PPPoE to Dual Stack PPPoE.

If you have a Huawei please enable IPv6 with DHCPv6 from the IPv6 settings.
Click to expand...

I have a DLInk with the orange gui (Hardware Version : G1, Firmware Version : 7.12)

Any idea what the settings would be ? I dont seem to have a dual stack IPv4 PPPoE option.
 
starmage said:
Try with https://test-ipv6.com/ or https://ipv6test.google.com/
I am currently running a HE tunnel - and ipv6-test.com says no IPv6 while test-ipv6 gives me a 10/10 mark (I can also confirm that IPv6 is acrtually running)
Click to expand...
No IPv6 address detected [more info]

Ready for the future of the Internet?​

No problems detected.
You don’t have IPv6, but you shouldn’t have problems on websites that add IPv6 support.


Windows 10 does have dhcp v6 addresses but:

tracert -6 2c0f:f4c0::b

Tracing route to 2c0f:f4c0::b over a maximum of 30 hops

1 General failure.

Trace complete.
 
minkukel said:
Update: Linux does have IPv6 internet, Windows does not. Eish, exactly why I want to read logs on the router
Click to expand...

Morning you would need to disabled the Ethernet adapter and enable it or unplug and plug it in again for it to get the IPv6 IP.
 
starmage said:
I have a DLInk with the orange gui (Hardware Version : G1, Firmware Version : 7.12)

Any idea what the settings would be ? I dont seem to have a dual stack IPv4 PPPoE option.
Click to expand...

Not so familiar with it but if we go through the wan settings I'm sure I can assist.

Can you take a screenshot of the WAN settings?
 
You must log in or register to reply here.
Back
Top
Sign up to the MyBroadband newsletter
X