Linksys WRT54G username?

[guest2013-1]

The username is suppose to be left blank, was wondering if someone could have changed this?

I have the password for the thing but its not accepting it with a blank password (tried IE7 and Firefox)

Any help getting into this little bitch would be nice. Tried connecting with it wirelessly, should I try using cable instead?

 

[Ryder_JHB]

admin/admin | admin/password | root/root | root/admin | root/blank | admin/blank?

 

[guest2013-1]

Will try the different combinations of usernames, the password has been changed to something including the default gateway, just not sure if it's possible to change the username to something custom as well (because that might be a bit screwed up right there).

Default settings says blank username and admin as password.

Will try root

 

[dadecoza]

afaik on dd-wrt if you use telnet/ssh instead of the web front-end the username is always root but the password stays the same.

 

[guest2013-1]

afaik on dd-wrt if you use telnet/ssh instead of the web front-end the username is always root but the password stays the same.

thanks, but how would I change settings? need to get into the web front end

 

[Nerfherder]

You can reset it (as a last resort)

 

[mancombseepgood]

The username is suppose to be left blank, was wondering if someone could have changed this?

I have the password for the thing but its not accepting it with a blank password (tried IE7 and Firefox)

Any help getting into this little bitch would be nice. Tried connecting with it wirelessly, should I try using cable instead?

Would it matter if you reset to factory defaults?
http://www.phenoelit-us.org/dpl/dpl.html
http://www.cirt.net/passwords?vendor=Linksys
http://www.wirelessforums.org/alt-i...d-not-valid-after-firmware-upgrade-24908.html

 

[guest2013-1]

You can reset it (as a last resort)

Yep I know, going to try and avoid that.

 

[mancombseepgood]

Would it matter if you reset to factory defaults?
http://www.phenoelit-us.org/dpl/dpl.html
http://www.cirt.net/passwords?vendor=Linksys
http://www.wirelessforums.org/alt-i...d-not-valid-after-firmware-upgrade-24908.html

Have you tried some of those default user names and passwords yet?

 

[guest2013-1]

how the hell do i telnet into it? says it doesnt accept on port 23

 

[guest2013-1]

Have you tried some of those default user names and passwords yet?

i know what the password should be, the username is blank as far as I can tell and from the documentation you can't change the username as far as I'm aware.... wtf

 

[dadecoza]

telnet in as root user type ...
nvram set http_username=''
nvram commit

I've just tested this, your http username will then be "root"

 

[mancombseepgood]

how the hell do i telnet into it? says it doesnt accept on port 23

Looks to me like someone really got a lil over protective on that one...
Are you telnetting over wifi? You might have to resort to cable for telnet connection.

 

[dadecoza]

how the hell do i telnet into it? says it doesnt accept on port 23

oops, my bad.

The service is probably not enabled.

 

[guest2013-1]

yea im telnetting over wifi, will try cable now and see if its any different

 

[guest2013-1]

no luck, seems i need to schedule some office downtime to setup the router again

 

[mancombseepgood]

Yep, in those cases you can curse linux for being so efficient with security