NeoFlex through other router

[Reptilian]

I have this setup,

Room 1: N-gen wireless router
Room 2: NeoFlex wireless router




how does one use the N-gen router to surf the internet through the NeoFlex routers connection, without any ethernet, preferably wireless only?

 

[ShadowRider]

I have done a similar setup. However here i have used a D-Link 3G router as my WIFI connection on the same network as my NeoFlex (a bit trickier) so I will try my best to give accurate help:

What i did:
1. Made sure that the New Router has a different IP address to that of the NeoFlex.
NeoFlex = 192.168.0.1 and N-gen = 192.168.0.2
2. Turned off the DHCP server and assigning IP addresses to the Specific Devices connected to it (in your case the N-gen).
3. The last thing is that sometimes the WIFI devices Gateway address is = to the WIFI router (N-gen) you would need to change it to the IP address of NeoFlex device manually.

My setup works great so far. Hope this helps you out.
Please feel free to make more suggestions on this setup!

 

[Valken]

@Reptilian

Does your router have a WAN Port?

Then you could setup your router's WAN port as DHCP to get a ip from the Neoflex router. Then you can connect to your N-gen's wireless and brows normaly.

If you can supply a bit more infoe on your router, i'll be able to assist you better. Feel free to pm me if you need more assistance.

I'm curently have my Neoflex connected to my lynksys router witch provides me with all the security and wireless acces i need...and some very acurate bandwith reports

Valken