poweralert stage 2.....

Status
Not open for further replies.
R5k for the software?

I paid like 3k back in 2020, came with the PI and the cables to connect to the Pylontech batteries so I can read the BMS from them for accurate battery data, as the inverter can only determine battery SOC based on voltage which is not great.
 
I paid like 3k back in 2020, came with the PI and the cables to connect to the Pylontech batteries so I can read the BMS from them for accurate battery data, as the inverter can only determine battery SOC based on voltage which is not great.
Thinking of springing for it for mine, as it's about 5k with a pi
 
I paid like 3k back in 2020, came with the PI and the cables to connect to the Pylontech batteries so I can read the BMS from them for accurate battery data, as the inverter can only determine battery SOC based on voltage which is not great.

In the end I have a lot of info on Home Assistant and can control the inverter from HA.

Screenshot 2023-05-22 at 09.59.10.png
 
I paid like 3k back in 2020, came with the PI and the cables to connect to the Pylontech batteries so I can read the BMS from them for accurate battery data, as the inverter can only determine battery SOC based on voltage which is not great.
What BMS info does it show? Can you change settings like balancing etc?
 
Thinking of springing for it for mine, as it's about 5k with a pi

I'd definitely recommend it - but I hear SolarAssist is also just as good if not better? It was not around when I got ICC, and since I have ICC I have not changed it as it does all I need.
 
Yes, but surely some nice quiet PC fans will stop the huge temp swings?

Probably. It has fans, it sits in the garage I don't hear it. When it blows up I'll replace it with a nice Sunsynk. This inverter was only 10k when I bought it and I figured if I got two years out of it, then great. Going on year three now.
 
Eskom is gonna be sending someone around to flip switches on your DB at this rate. Circuits with geysers, inverters, and heaters are now blacklisted.
 
Nope, a cheap Kodak Inverter, connected to a raspberry PI that runs a bit of software called ICC - which then I connect Home Assistant to get the MQTT messages

You got a mini tutorial on how you hooked up the home assistant to the icc?

They'll have to pry my suicide cable from my cold dead hands.

You mean hot-and-melted-electrically-charged dead hands.

:ROFL:


Yea that's not happening with the automatic nature of inverters. Do you even get some sort of current delay to be installed in a DB?
 
Status
Not open for further replies.
Top
Sign up to the MyBroadband newsletter
X