Route Sentry and Windows 7

[SlyFly]

Just wondering does it work? Also does it work Vista or XP way?

 

[killadoob]

Should do you would need to test it though.

 

[StoneCold]

It works yes, in the Vista way

 

[Pooky]

Hey there was a post documenting how to install this on Windows 7 does anyone have the link to it?

 

[wikus]

Also waiting for this as I tried the two different ways of installing Route Sentry namely the half-bridge/one ppoe connection and the bridge/two ppoe connection modes. None worked, as I expected.
I have also switched off the digitally unsigned drivers block on my 64-bit version.

If the Vista way works on Windows 7 64-bit, can someone please post the link to that thread?

Never mind, got a page with a supposed solution...haven't tested if it works

 

[Hunted]

Route Sentry works just fine on Windows 7 x64. I upgraded to RC1 from Vista. Only thing I needed to do was to set the exe to be run as administrator and that was it.

 

[nSidious]

Yep works 100% in Windows 7, the xp or the vista way. It's Bi

1) Regedit... search for Wanendpoints and make sure their values are >1
2) Create two PPPOE connections in the Windows 7 Network center
3) Right click on each connection, goto settings, IPv4. click on advanced and take the tick off "use default gateway"
4)Install Routesentry, run as admin and you away.

Check the Routesentry thread if you don't believe me

 

[Surv0]

Im experiencing a funny problem with RS. once ive made the connections the routing table entries in the log gave errors. I could only use one of the active connections, the other refused to work. Disconnecting the local connection and reconnecting it, the route table gets created without issue but then the international connection doesnt work. Ive tried a couple different ways and final result is to close route sentry and disconnect, then reconnect and the connection would work again. I added the new routes so not sure what the prob could be.

Win 7 x64

Any Ideas?

 

[camerongf]

An odd problem

I've just set up Route Sentry on Windows 7 Ultimate x64 and it works fine. The only problem is that I've lost connection to my private home network. It's very strange... Before I open Route Sentry, when I go to "Network and Sharing Centre" I can see my "Home Network" but as soon as I start Route Sentry and connect to the two accounts, immediately "Home Network" disappears and is replaced by "Unidentified Network". I am then unable to access any of the other computers on my LAN including my router, which is not cool...

Anyone else had the same problem and managed to fix it?

 

[Armgame]

I have same problem as Suv0 error 831, a connection already connected and s*** like that