@kianm
whats your setup with mikrotik e.t.c
I run an Ubiquiti network and realized I can use my USG gateway's WAN2 port to route over two connections. The USG doesn't do policy based routing so I couldn't setup time based routes, you can only select load balancing or failover to WAN2.
To make it work I then switched my uncapped to WAN2 and plugged another router with the 500GB sim to WAN1 then set the 2 connections in failover mode(WAN1 primary WAN2 failover).
The idea is the USG prefers to use WAN1 so from 7am to midnight the USG will be routing over failover link WAN2 but constantly checking if WAN1 is back online and soon as the clock hits 12am the 500GB (WAN1) comes up and the default route changes to WAN1 till 7am.
Still testing the setup the challenge is I don't trust the reliability of the spare router I plugged into WAN1 I'm going to have to maybe get a B593 or something to properly test this setup. It's working somewhat but I think the spare router is my problem the speeds are not great and there is packet loss. If this later proves to be 100% reliable then I'll ditch the Mikrotik plan
Last edited: