Jet-Fighter7700
Honorary Master
Hi all, so let me run though my issue.
Want to change my SSID and password to my network, got a netgear D6200.
Not sure what ip address it was configured as,
Try a reset, comes back the same, still defaults and again can't figure out what the ip address is.
If I plug out all ethernet cables and leave it standing alone, still can't login to the router config page.
Try all the default addresses 0.1, 1.1 but get other things and not my router, even after a reset.
Router is working as far as I can understand in bridge mode, as devices do work fine, but resetting does nothing, (suspect reset pin been disabled).
What other alternatives are there at this point?
Tried searching via ip scanners for it's mac address, can't find it anywhere.
Want to change my SSID and password to my network, got a netgear D6200.
Not sure what ip address it was configured as,
Try a reset, comes back the same, still defaults and again can't figure out what the ip address is.
If I plug out all ethernet cables and leave it standing alone, still can't login to the router config page.
Try all the default addresses 0.1, 1.1 but get other things and not my router, even after a reset.
Router is working as far as I can understand in bridge mode, as devices do work fine, but resetting does nothing, (suspect reset pin been disabled).
What other alternatives are there at this point?
Tried searching via ip scanners for it's mac address, can't find it anywhere.
