Centurion D3 pin programming using set pin

[storms1]

hi all
So Centurion D3 acting up on one the remotes needed to be reprogrammed.. The set pin on the board is missing something not quite sure of it broke off ..see pic how can see or fix this maybe someone can verify against their Centurion D3

thanks

 

[storms1]

hi all
So Centurion D3 acting up on one the remotes needed to be reprogrammed.. The set pin on the board is missing something not quite sure of it broke off ..see pic how can see or fix this maybe someone can verify against their Centurion D3

thanks

I compared it to D5 standard and it's not remotely the same ..

 

[WAslayer]

Not sure if I am missing something but I see two pins for the set function..?

 

[biena]

The SET pins is fine just missing a jumper if you want to change gate parameters.
Programming remotes is not done through that SET pin. Its on a separate board. Post a picture of your remote as there are quite a few different ones out there. nova/sherlo/et etc. Could also be that the remote in question needs a battery change.

jumper. bridges set pins for programming the gate


nova remotes

Sentry, Sherlo or E.T. remote controls

 

[thehuman]

That looks like d5 board, follow trigger cable green to your receaver

 

[thehuman]

The green wire with TRG written beneath it

Those old motor controllers is not easy to work with, there also no more support from centurion for that model motor