Nat Settings????

[DewaldB]

Dont really know where else to post this.

My friend my brother and myself all three have xbox 360's with Red Dead Redemption but none of us can get into the same game it gives an error telling us something about nat settings too strict and then it disconnects and then it puts you in a multiplayer game all by yourself.

I phone Axxesss and they told me to type in 10.0.0.2 to het to the modems settings and I did he then told me that we were going to do port forwarding and we did we typed in all three xbox's IP's in and they guy said it should be fine. But afterwards I tried to do a test on the xbox for connection this time saying connection is moderate not strict anymore but then all a sudden the net went off and we couldnt get back on neither on the pc or xbox.

So I went back to port forwarding and typed 10.0.0.2 agian and took out the xbox ips and then the net was connected again any help please..

I dont know much about this type of stuff and we really want to play this game any help would be much appreciated!!!!

The modem is Siemens Giga 762SX

 

[Drake2007]

I don't know that game at all but you need to check if you can set the port that the game uses as all three need to be different, and then port forward those respective IP addresses and ports to each xbox on the Router. Otherwise NAT won't know which IP to port map to. Alternatively enablling uPNP on the router and maybe also in the game might work.

 

[DewaldB]

I tried what you said but the connection is still strict on the xbox!

 

[bboy]

Ratherremove the port fowarding and look for a DMZ setting, put your xbox ip in there and try that.
Its a simpler approach basically telling the router to send all unhandled incoming traffic to the xbox.
Alternatively you could add a pppoe connection on your xbox if your router supports half bridged mode.