gate motor

  1. PegZ

    ET 500 Gate Motor not using AC

    Hi All, My ET500 stopped using AC. I tested the transformer 220 V -> 18 VAC. I tested 18 VAC at transformer but only about 4 to 5 VAC at motor control board, when disconnecting the plug, then there's about 17.8 VAC on the wire, so I guess that possibly means something wrong at the PCB pulling...
  3. M

    Sonoff SV and Centurion Status LED

    Hey everyone, I’ve noticed a lot of posts about using the Sonoff SV on folks gate motors and a I’ve seen HA covers where the gate status is shown (open/closed). I’ve seen some people use reed switches however, fortunately my Centurion D5 motor has a status pin which turns on an LED of the gate...
  4. M

    How to connect gate motor to battery system? Hansa Elite H/D

    Hello, So some a**hole/s today decided they would like access to my property and cut the lock that connects the motor's arm to the gate but luckily they didn't gain access to the house. I have connected a better locking system but the gate hasn't got a backup system so it has to be manually...
  5. P

    ET500 gate motor problem

    Hi, I've searched the existing threads and could not find help for my problem, so am writing this new post. I have a dual gate system with two ET500 motors. One recently would not close properly. I checked for rolling resistance manually (with pinion disengaged), but could feel anything or...
  6. D

    Centurion D5 battery replacement. Original or aftermarket?

    So the battery finally gave up on my Centurion gate motor. Should I buy the original Centurion battery from TAL or would it be better to buy another brand of battery? Suggestions?
  7. P

    D5 Evo motor problems

    My D5 Evo Electric gate was fine , one morning when I tried to open it i got a message motor fault. Disconnected. I checked all wires and installed a new battery. Give motor direct power and it work fine. When I tried to restart the gate motor I got Set limits... Doing the reset limit steps it...
  8. J

    Old Gemini motor - how to read statuses from circuit board for Automation

    Hi, I want to add an ESP8266 into my Gemini Gate Motor casing, which can then read on its pins statusses from the circuit board, such as: - Gate Open - Gate Closed - Gate Opening - Gate Closing - Gate Jammed (Stopped, but not yet open or closed) I will take this data through MQTT to Node-Red...
Back
Top
Sign up to the MyBroadband newsletter
X