Cannot access 10.0.0.2 at all

[melaniejm]

Changing settings on CMD

check your pc's ip setting by running ipconfig from the command line. You need to ensure that your local network setting is in the 10.0.0 range. try setting it to a manual setting of 10.0.0.100, gateway 10.0.0.2 dns 10.0.0.2

Hi, how do you manualy change the gateway and local network setting on the command line?? Thanks! Mel

 

[Divine Master of Unknown]

Hi, how do you manualy change the gateway and local network setting on the command line?? Thanks! Mel

You don't.

You go to network settings and change the IPv4 settings

 

[irBosOtter]

Hi, how do you manualy change the gateway and local network setting on the command line?? Thanks! Mel

To set IP:
netsh interface ip set address name=”Local Area Connection” static 10.0.0.100 255.255.255.0 10.0.0.2

To Set DNS:
netsh interface ip set dns name=”Local Area Connection” static 10.0.0.2

 

[smith821]

hi I'm trying to access my router but the steps they show I cant see them at all.
the username and password doesn't show at all

(Open your internet browser and​

go to http://10.0.0.2 and click

Enter. Type in admin for both

the username and password. Click​

Login.)

 

[Rickster]

hi I'm trying to access my router but the steps they show I cant see them at all.
the username and password doesn't show at all



(Open your internet browser and

go to http://10.0.0.2 and click

Enter. Type in admin for both
the username and password. Click
Login.)

Are you sure your router is on 10.0.0.2?

 

[SauRoNZA]

hi I'm trying to access my router but the steps they show I cant see them at all.
the username and password doesn't show at all

(Open your internet browser and​

go to http://10.0.0.2 and click

Enter. Type in admin for both

the username and password. Click​

Login.)

Don’t use Internet Explorer or Edge.