Custom PC case - Multi Hex MKII

It is all in the details ;) Even the screws have hexes!

zdDT8GH.jpg


9HqL6M0.jpg


cFkeloJ.jpg


BTBhgSc.jpg


Otherwise the only other thing I had time for was a test fit of the motherboard again, but with the actual standoffs I will be using. Everything lined up perfectly :D
 
Went to buy some imperial bolts (its for the radiator)... R10 per bolt!!! :mad: I politely declined

I'm going to try drill out the holes and rethread it into metric. I'm not quite sure though if it is going to be possible with the tools I have and I'll need to be careful not to puncture the rad
 
Making progress :) Far enough that I can enjoy it, and I'll likely leave it as is until after the 25th. I should probably also clean my desk :p

v4K36Ke.jpg


C4aELab.jpg


CUnmlEV.jpg
 
Hadn't done the cabling because I needed two 3m DVI dual cables for my monitors. All the DVI cables I bought didn't support higher than 1080p. Took a while to get the proper ones for my 27" 1440p monitors.

Cables behind the perspex unfortunately not long enough to run nearly as neatly as I wanted. But I'm OK with that.
 
Last edited:
You must log in or register to reply here.
Back
Top
Sign up to the MyBroadband newsletter
X