W@P's Solar System

So I ordered a Dektite Lead Flashing for my father's installation but the order took too long to arrive and installation was done. Is anyone interested make me an offer?

DEKS-Dektite-Nu-Lead-Multicable-Solar-Flashing-Tiled-or-Slate-Roofs_1024_1024x1024@2x.jpg
 
I need some help guys. My father's panels were installed and all is looking good. However, the panels only charge the bubbles to around 93% then stop.

I checked all his settings and they are exactly the same as mine. I cannot figure out why this is happening. Not sure if it could be a firmware thing?

If i turn the batteries off and on they start charging again for a minute or 2 then stop. He was charging them from the grid before we installed the panels and that worked fine.

Any ideas?
 
W@P said:
I need some help guys. My father's panels were installed and all is looking good. However, the panels only charge the bubbles to around 93% then stop.

I checked all his settings and they are exactly the same as mine. I cannot figure out why this is happening. Not sure if it could be a firmware thing?

If i turn the batteries off and on they start charging again for a minute or 2 then stop. He was charging them from the grid before we installed the panels and that worked fine.

Any ideas?
Click to expand...

Post a custom graph of the batteries' V-Bat and V-BMS parameters.
 
W@P said:
Hope this helps.

View attachment 1364663
Click to expand...
Looks OK-ish, but take away the SoC, I want to see just the two together and the biggest difference between the two.

Do you have a Cloudlink? If so, then you can see realtime whether the BMS is disallowing charging, it won't display Chr Allow like this:
1660544229487.png
 
If I take away the SOC it still shows the same line for the other 2. I have a Riot, will install later today.
 
Also, what firmware versions is your inverter on? It looks a little dated...
 
W@P said:
If I take away the SOC it still shows the same line for the other 2. I have a Riot, will install later today.
Click to expand...
The voltage difference is quite important, it can show if you have a bad connector / cable, or if you have a sick inverter. You can also try doing full shutdown and restart, and if that does not work, a factory reset.
 
Yes it might be a bit dated. Not sure what version it is atm. Too fscking scared to do a firmware upgrade after what happened to me last time round.
 
W@P said:
Yes it might be a bit dated. Not sure what version it is atm. Too fscking scared to do a firmware upgrade after what happened to me last time round.
Click to expand...
Sometimes it is necessary, like when you are having issues.
 
Thanks, will revert back after i got the Riot connected.
 
Mike Hoxbig said:
Is the bank capacity really 220Ah, or should it be 200Ah? Could be a reporting thing because of that. 200/220*100=91%...
Click to expand...
Mine is set to 220Ah for 2x Hubbles. Hubbles website suggests 110Ah for 1 x Hubble.
 
Speedster said:
I believe that has been adjusted to 100Ah due to "issues"
Click to expand...
Yes i am aware of that issue. Still, I left my own settings the same as on their website. No issues by me. The grid was charging these batteries to 100% every day before the PV was installed. After installation, it started.

I managed to set up the Riot. And also I reset both batteries via the reset button at the bottom. They instantly started charging up to 100% from PV. I hope that has resolved the issue. I will keep an eye on it.

Thanks for all the suggestions.
 
You must log in or register to reply here.
Back
Top
Sign up to the MyBroadband newsletter
X