Draytek router

[sycogrim08]

Hi All

I recently setup tunnels between my office and 3 different sites and managed to get them to see each other... now what i did was duplicate the exact same settings obviously adjusting a few things to for the sites to see each other but i do not get any luck.... i dont quite understand why its doing this... nothing is different just the IP addresses are....

this is how my setup is


Lan IP
Office: 192.168.1.1
Site 1: 192.168.23.1
Site 2: 192.168.24.1
Site 3: 192.168.25.1

Wan IP
Office: 10.168.1.1
Site 1: 10.168.2.23
Site 2: 10.168.2.24
Site 3: 10.168.2.25


Site 1,2,3 can see the office and the other way round

now im trying to get Site 1 to see 2 and 3 and the same for the other 2.... i even tried to add them to the current tunnel running through me to see each other but that doesnt seem to work either.... i dunno what else to do.... if i do a tracert from the draytek i see that it sits in the tunnel and if i ping the WAN2 IP i get a response....

If anyone can assist pls lemme know.

Thanks

 

[Gambit]

You will need to add static routes to the routers at site 1, 2 ,3. These routes must route all traffic for the other sites via the office tunnel.

 

[sycogrim08]

You will need to add static routes to the routers at site 1, 2 ,3. These routes must route all traffic for the other sites via the office tunnel.

These are currently static routes.... but would i have to set static routes on the Drayteks themselves????

 

[Gambit]

These are currently static routes.... but would i have to set static routes on the Drayteks themselves????

If the drayteks are the gateways of these networks then yes. The problem you have is that the gateways on the site networks don't know that all traffic destined for the other sites must be routed via the office.