Paradox alarm issue

[undesign]

Hi there, hoping someone can offer ideas.

Problem:
Alarm seems to randomly go off at night, but no zone showing as triggered, only “area 1” which is partition 1.

If a normal zone is triggered eg outside beam Zone 10 then the zone 10 light is lit on the console and it is communicated correctly to the AR via Olarm.

The “false” alarm is communicated to AR as zone 1 (even though I think they mean area 1) and no zone showing on the console.

Technician seems to be stumped.

Any ideas? Thanks!

 

[krieg]

Hi there, hoping someone can offer ideas.

Problem:
Alarm seems to randomly go off at night, but no zone showing as triggered, only “area 1” which is partition 1.

If a normal zone is triggered eg outside beam Zone 10 then the zone 10 light is lit on the console and it is communicated correctly to the AR via Olarm.

The “false” alarm is communicated to AR as zone 1 (even though I think they mean area 1) and no zone showing on the console.

Technician seems to be stumped.

Any ideas? Thanks!

When a zone gets tripped it gets communicated as partition and zone number so it would always be one unless you have two partitions. You can connect your alarm to a Pi and load the PAI software to get a better idea of the error messages, I would also verify that the zones is still programmed correctly.