Home Automation - Smartkit

Quick Q: In the Tasmota firmware for the Sonoff wifi switches with power monitoring, is there a console command to display current power, voltage, Hz? I've scanned through the wiki but can't find it.
 
mtlost said:
For when the interwebs go down. Taking control back to your local network, independent of the internet and China cloud servers........and yes, when you start using multiple platforms.
Click to expand...

Already has Lan control as is. Multiple platform point accepted though. :thumbsup:
 
Arthur said:
Quick Q: In the Tasmota firmware for the Sonoff wifi switches with power monitoring, is there a console command to display current power, voltage, Hz? I've scanned through the wiki but can't find it.
Click to expand...

Should be in the Stat update every 300ms by default as I recall.

Not Hz though.

****

Actually I guess this would only be with MQTT enabled. You’ll see it in in the GUI otherwise.
 
SauRoNZA said:
Should be in the Stat update every 300ms by default as I recall.

Not Hz though.

****

Actually I guess this would only be with MQTT enabled. You’ll see it in in the GUI otherwise.
Click to expand...
I'd like to see it in the GUI in a browser. So far I haven't found a way to display anything other than friendly name, wifi info, IP, etc.

Would be great to see the load.
 
Arthur said:
I'd like to see it in the GUI in a browse. So far I haven't found a way to display anything other than friendly name, wifi info, IP, etc.

Would be great to see the load.
Click to expand...

Have you set the type of Sonoff? Then it shows right there on the front page of Tasmota.

You could also use Tasmoadmin to pull it into a separate interface.
 
Anyone had any joy in hooking up a SonoffSV to a traditional home alarm system? I want to be able to arm/disarm and also get feedback on the armed status via the GPIO pins? Have two of these running my driveway gate and garage door and works like a charm. Being able to control the alarm system also will be great.

I know the 4ch PRO can be hooked up to a paired remote but not ideal.
 
skefda said:
Anyone had any joy in hooking up a SonoffSV to a traditional home alarm system? I want to be able to arm/disarm and also get feedback on the armed status via the GPIO pins? Have two of these running my driveway gate and garage door and works like a charm. Being able to control the alarm system also will be great.

I know the 4ch PRO can be hooked up to a paired remote but not ideal.
Click to expand...

Yes.

To a very old Spectra board that allows for a push button/key switch arm (which is how the remote works) alongside programming the PGM Relay.

Without the PGM relay not sure you’ll be able to get the status out.
 
skefda said:
Anyone had any joy in hooking up a SonoffSV to a traditional home alarm system? I want to be able to arm/disarm and also get feedback on the armed status via the GPIO pins? Have two of these running my driveway gate and garage door and works like a charm. Being able to control the alarm system also will be great.

I know the 4ch PRO can be hooked up to a paired remote but not ideal.
Click to expand...

Should be able to do (via the key and the siren), I was about to attempt the same with an RE5V1C.
 
What makes it smart
167b5f2b36bb4d441caab75a7c31fbaa.jpg
 
Hey home automation nerds.

Today is the day for the Home Assistant “State of the union” address hosted by Paulus Shoutsen the founder of Home Assistant. Looking forward to hearing what is being planned for the coming year.

Live stream starting at 19:30 SA time!

 
You must log in or register to reply here.
Back
Top
Sign up to the MyBroadband newsletter
X