Good day,
I've setup a new Tenda RX2 WiFi 6 Router and did the setup the WiFi of my Canon MG3040. The printer indicates it is connected to the WiFi. The router's device page shows the printer. I've place the router in Unify 2.4 GHz & 5 GHz mode. The video from Canon does states that the router needs to have a 2.4 GHz channel.
The problem is that prints from a laptop (Windows) and my PC (Linux, wired network to that router) takes more than 5 minutes before the print starts. On the old router the print started under a minute.
How can I troubleshoot this issue?
I've setup a new Tenda RX2 WiFi 6 Router and did the setup the WiFi of my Canon MG3040. The printer indicates it is connected to the WiFi. The router's device page shows the printer. I've place the router in Unify 2.4 GHz & 5 GHz mode. The video from Canon does states that the router needs to have a 2.4 GHz channel.
The problem is that prints from a laptop (Windows) and my PC (Linux, wired network to that router) takes more than 5 minutes before the print starts. On the old router the print started under a minute.
How can I troubleshoot this issue?