The Home Improvements Thread (2)

Status
Not open for further replies.
xrapidx said:
Will look into it - my tank is probably 20m from the pump though.
Click to expand...
Doesn't matter, the pressure switch is definitely what you want, it will also only turn the pump on when the irrigation runs or you open a tap. Make sure you don't have any leaks, as this could turn the pump on and off every few seconds. You can also automate the water flow into your tank from your WellPoint using probes that check for level.
 
ElixirCoder said:
Doesn't matter, the pressure switch is definitely what you want, it will also only turn the pump on when the irrigation runs or you open a tap. Make sure you don't have any leaks, as this could turn the pump on and off every few seconds. You can also automate the water flow into your tank from your WellPoint using probes that check for level.
Click to expand...
Isn't that then the booster pump though, where the pressure switch goes?
 
xrapidx said:
That part makes sense to me, it's the trigger for the wellpoint pump I'm after, they can't run off the same trigger as they have different flow rates.

Wellpoint is 2-10L/min at this stage.
Click to expand...
Mmmm that's a bit slow so you do have a risk of a dry run. I'd definitely look into a booster pump with dry run protection like this: https://ecodepot.co.za/products/ecodepot-0-37kw-booster-pump-pressure-controller-tank-connector-kit

Float switch is what you need for the WellPoint pump to automatically turn on/off based on tank level.

ecodepot.co.za

HT Float Switch with 5-metre Cable & Counter-Weight

Great prices on HT Float Switch With Cable 5M & Counter-Weight, on EcoDepot today! Limited stock. We deliver nationwide. Shop now
ecodepot.co.za ecodepot.co.za
.
 
Thanks - I doubt I'll run dry, its a 2500L tank - and at most will run for 40min a day.

The booster pump will be right at the tank, going to do the electrical this weekend.

The wellpoint pump is still an issue - longest float switch i can find is 10m - and I need about 25m - not sure if they're easy to extend.
 
ElixirCoder said:
is that the distance to your point?
Click to expand...

Distance from the pump to the tank - can't move it as the tank is above paving, so it'll mean running new piping, etc - which I'm really not in the mood for (it also means I have to pull the water another 25m)
 
xrapidx said:
Distance from the pump to the tank - can't move it as the tank is above paving, so it'll mean running new piping, etc - which I'm really not in the mood for (it also means I have to pull the water another 25m)
Click to expand...
Sorry, I meant why not put a control switch near your tank if you have electricity close by?

Takealot.com: Online Shopping | SA's leading online store

South Africa's leading online store. Fast, reliable delivery to your door. Many ways to pay. Shop anything you can imagine: TVs, laptops, cellphones, kitchen appliances, toys, books, beauty & more. Shop the mobile app anytime, anywhere.
www.takealot.com www.takealot.com
 
ElixirCoder said:
Sorry, I meant why not put a control switch near your tank if you have electricity close by?

Takealot.com: Online Shopping | SA's leading online store

South Africa's leading online store. Fast, reliable delivery to your door. Many ways to pay. Shop anything you can imagine: TVs, laptops, cellphones, kitchen appliances, toys, books, beauty & more. Shop the mobile app anytime, anywhere.
www.takealot.com www.takealot.com
Click to expand...

I plan to for the booster pump - it's the wellpoint pump that's the issue. It can't be moved and is 20m away from the tank
 
xrapidx said:
I plan to for the booster pump - it's the wellpoint pump that's the issue. It can't be moved and is 20m away from the tank
Click to expand...
ok, let me try and explain it better, my apologies for the confusion.

Do you have an electrical point near your tank?

If so, you can use a small DB and install two control switches: one for your booster pump and one for your WellPoint pump -- both situated at the DB close to your tank (if this is possible). Then all you need is your float switch from your tank to go to the control switch for your WellPoint, and the other control switch to be wired into your booster pump. Then you don't need to try and extend the float switch cable.
 
ElixirCoder said:
ok, let me try and explain it better, my apologies for the confusion.

Do you have an electrical point near your tank?

If so, you can use a small DB and install two control switches: one for your booster pump and one for your WellPoint pump -- both situated at the DB close to your tank (if this is possible). Then all you need is your float switch from your tank to go to the control switch for your WellPoint, and the other control switch to be wired into your booster pump. Then you don't need to try and extend the float switch cable.
Click to expand...

Duh - thanks. Didn't think of that.
 
I want to build a floating tv stand, almost similar to this in the link:


However, I am a bit concerned about the brackets or the wall mountings that will keep it up, and the wood that needs to be used.

It must house my Receiver, my computer, and my center speaker.

I want holes for 3 200mm fans on the both side of the cabinet but it must be hidden by the wood.
I also want smaller holes on the top so that I can add wireless charges to it, and the wooden top will be covered by glass.

So.... My computer and receiver is very heay. What wood would you guys recommend for this build?
 
CamiKaze said:
I want to build a floating tv stand, almost similar to this in the link:


However, I am a bit concerned about the brackets or the wall mountings that will keep it up, and the wood that needs to be used.

It must house my Receiver, my computer, and my center speaker.

I want holes for 3 200mm fans on the both side of the cabinet but it must be hidden by the wood.
I also want smaller holes on the top so that I can add wireless charges to it, and the wooden top will be covered by glass.

So.... My computer and receiver is very heay. What wood would you guys recommend for this build?
Click to expand...

I bought one from ODE. One long floating double desk. I can sit on it and it doesn't move a mm.
 
CamiKaze said:
I want to build a floating tv stand, almost similar to this in the link:


However, I am a bit concerned about the brackets or the wall mountings that will keep it up, and the wood that needs to be used.

It must house my Receiver, my computer, and my center speaker.

I want holes for 3 200mm fans on the both side of the cabinet but it must be hidden by the wood.
I also want smaller holes on the top so that I can add wireless charges to it, and the wooden top will be covered by glass.

So.... My computer and receiver is very heay. What wood would you guys recommend for this build?
Click to expand...
Well, what are your concerns? regarding the wall mounting, I'm assuming either some kind of metal bracket or directly screwed into the wall? Either way, good old rawl bolts will do the job. for the fans, you can point them down from the rear, so nobody will see them. Cover them with a mesh on the inside to prevent something falling into them.

Regarding wood, depends entirely on your taste. A good solid wood will do the job. I'd stay away from chipboard or MDF.
 
ElixirCoder said:
Well, what are your concerns? regarding the wall mounting, I'm assuming either some kind of metal bracket or directly screwed into the wall? Either way, good old rawl bolts will do the job. for the fans, you can point them down from the rear, so nobody will see them. Cover them with a mesh on the inside to prevent something falling into them.

Regarding wood, depends entirely on your taste. A good solid wood will do the job. I'd stay away from chipboard or MDF.
Click to expand...

My concerns: Will the wood not bend with all the weight?
 
Status
Not open for further replies.
Back
Top
Sign up to the MyBroadband newsletter
X